E-JETS-FANFLIGHT COMPANION
FOR MICROSOFT FLIGHT SIMULATOR 2024FLIGHTSIM STUDIO E-JETS
FLIGHTSIM STUDIO E-JETSE170E175E190E195
E-JETS / FLIGHT COMPANION / IESS OPERATIONGuide overview
STANDBY / IESS

IESS operation

E190 instrument panel
E190 instrument panel [213]

Find the IESS

Identify the integrated standby display and make sure it is powered and readable. FSS says alignment takes about 90 seconds; allow it to finish before comparing the indications.

Check attitude

Compare the standby attitude indication with the primary displays and the aircraft’s actual state.

Check speed and altitude

Compare standby values with the primary displays, allowing for the relevant source and pressure setting.

Set barometric pressure

Use the IESS BARO knob to set its pressure reference and check the value on the standby display. For standard pressure, use its STD button. Compare the standby setting with the reference used on the primary displays.

Check approach display if needed

FSS describes an ILS button for ILS 1 deviations. Check whether the button and deviation information are available in your installed build.

CAGE not simulated

FSS explicitly says CAGE is not simulated. Do not apply the real-aircraft cage procedure to this add-on.

The standby airspeed digits show calibrated airspeed. FSS also lists an IESS refresh-rate limit under EFB Aircraft → Display Refresh Rate. FSS IESS [214].