Flight-plan entry and review

Set your SimBrief username or user ID in NAV → DATALINK → ADDRESS → FLIGHTPLAN. On RTE, enter the origin, destination and flight ID to match the OFP, then request the flight plan. Review the resulting route before making it active.

The Preflight Setup and SimBrief Import pages call the request DLK PFL and offer CO ROUTE. The current RTE and DATALINK pages use DLK FPL and SEND; the RTE page says CO ROUTE is not implemented. In one November 2026 support thread, users discussed both the company address and CO ROUTE; the original poster later reported success without identifying what resolved the issue. This is one report, not a verified general workaround. Use the prompt shown by your installed version and inspect every imported leg before activating the route.

Choose the departure runway, SID and transition as applicable. Do the same for the arrival and approach. Inspect every leg and discontinuity against the chart and clearance. Do not remove a discontinuity unless you understand what joining the legs will command.

On PERF INIT, compare cruise altitude, fuel, ZFW, takeoff CG and gross weight with the EFB and plan. Imported performance comes from the OFP and may not match the aircraft. Complete the required fields and press CONFIRM INIT on page 3/3. FSS says the vertical profile and VNAV data are unavailable until this is confirmed; after any PERF INIT change, confirm again before checking the recalculated profile.

Set takeoff configuration, trim and speeds from the applicable FSS performance information for this aircraft and conditions. Takeoff pitch and stabilizer trim are different things.